Start a conversation

How to control the touch mode?

By default the Displax Touch Controllers are automatically defined with the correct touch mode for each operating system. There are three possible modes to be defined:

  • Mouse emulation (0)
  • Single Touch (1)
  • Multitouch (2)

If for some reason there is the need to force this mode just follow these steps in any of the supported  operating system.

skin -dmode
  • To set the Touch Controller to    mouse emulation
skin -dmode 0 perm -ssave
  • To set the Touch Controller to    Single Touch
skin -dmode 1 perm -ssave
  • To set the Touch Controller to    Multitouch
skin -dmode 2 perm -ssave
  • If you want to allow the Touch Controller to define this mode automatically just      run
  skin -dmode 2 raw -ssave -dreset
Choose files or drag and drop files
Was this article helpful?
Yes
No
  1. Vitor Sousa

  2. Posted
  3. Updated

Comments