Start a conversation

[Command Line] How to control the touch operation mode

By default the Displax Touch Controllers are automatically defined with the correct touch mode for each operating system. There are three possible modes to be defined:

  • Mouse emulation (0)
  • Single Touch (1)
  • Multitouch (2)

If for some reason there is the need to force this mode just follow these steps in any of the supported  operating system.

skin -dmode
  • To set the Touch Controller to     mouse emulation
skin -dmode 0 perm -ssave
  • To set the Touch Controller to     Single Touch
skin -dmode 1 perm -ssave
  • To set the Touch Controller to     Multitouch
skin -dmode 2 perm -ssave
  • If you want to allow the Touch  Controller to define this mode automatically just       run
  skin -dmode 2 raw -ssave -dreset
Choose files or drag and drop files
Was this article helpful?
  1. Vitor Sousa

  2. Posted
  3. Updated