Start a conversation

Displax Connect Command Line

Tweak your touch sensor with the extensive shell command list we have available

  • How to access the Displax Connect Command Line?

    This tool can be found on the same folder where the Displax Connect is installed (Windows and macOS). If you type skin -h you will see all the possible parameters you can use with the command skin, th...

  • [Command Line] How to activate TUIO

    All Displax products offer the end users the possibility to activate the TUIO protocol, allowing them to get over the network values: X coordinate; Y coordinate; Pressure Sensing (only for Displax Ski...

  • [Command Line] Enable/disable the touch injection in the Operating System

    With the Displax Connect Command Line you are able to control if the touch is being injected on the Operating System or not. In order to achieve this in any of the supported operating system follow th...

  • [Command Line] How to control the touch operation mode

    By default the Displax Touch Controllers are automatically defined with the correct touch mode for each operating system. There are three possible modes to be defined: Mouse emulation (0) Single Touch...

  • [Command Line] Restart the touch controller

    In  order to achieve this in any of the supported operating system follow these steps:     Be sure that you are on the location of the Displax Connect installation To archive this run the following co...

  • [Command Line] How to set/get the Threshold

    Displax Connect Command Line gives you the possibility to set/get the threshold over the command line. In  order to achieve this in any of the supported operating system follow these steps: Be sure th...

  • [Command Line] Factory reset the Touch Controller

    Displax Connect Command Line gives you the possibility to factory reset all values. In  order to achieve this in any of the supported operating system follow these steps: Be sure that you are on the l...

  • [Command Line] Load/save the settings of a Touch Controller

    Displax Connect Command Line allows you to load or save all the settings and calibration values from one Touch Controller to another with the same model and firmware version. In  order to achieve this...

  • [Command Line] Create a new frame of reference

    The frame reference feature consists in making the actual frame data the one that is going to be used for reference when the system tries to determine if we are get a touch or not. In  order to achiev...

  • [Command Line] List all the Touch Controllers connected

    Displax Connect Command Line gives you the possibility to list all the Touch Controllers connected to a machine. In order to achieve this in any of the supported operating system follow these steps: B...