Loading...

Touch operation mode

Home/Touch operation mode

Touch operation mode

By default, the Displax Touch Controllers are automatically defined with the correct touch mode for each operating system. There are three possible modes to be defined:

  • Mouse emulation (0)
  • Single Touch (1)
  • Multitouch (2)

If for some reason there is the need to force this mode just follow these steps in any of the supported operating system.

  • To check what is the actual mode that is defined
displaxservice -a 127.0.0.1 --dmode
  • To set the Touch Controller to mouse emulation
displaxservice -a 127.0.0.1 --dmode 0 perm --device-settings save
  • To set the Touch Controller to Single Touch
displaxservice -a 127.0.0.1 --dmode 1 perm --device-settings save
  • To set the Touch Controller to Multitouch
displaxservice -a 127.0.0.1 --dmode 2 perm --device-settings save
  • If you want to allow the Touch Controller to define this mode automatically just run
displaxservice -a 127.0.0.1 --dmode 2 raw -device-settings save --dreset