Calibrate 1 Tile

If you are using a single Tile unit, the calibration process is similar to a single Displax Skin.

Go to the CALIBRATION tab, and click on the CALIBRATE button:

4 calibration targets will appear. Start by touching target number 1 until the green circle completes. Repeat the process for targets 2, 3, and 4.

• Related Articles

• Calibrate 2 or More TILEs

  The process of calibrating 2 or more TILE units would be exactly the same, regardless of how many TILE units you are using. In the following example we demonstrate 3 TILE units working as a Videowall (3 Columns and 1 Row). First, select the TILE you ...

• RS232 Connection

  RS232 Daisy-Chain Connection Instructions DISPLAX TILE units can be daisy-chained via RS232 connection using RJ45 cables. This connection is required when configuring and merging TILE units using the internal videowall processor and VIDEOWALL CONTROL ...

• Recommended Hardware

  Recommended Hardware for DISPLAX Tile To ensure stable performance, accurate touch detection, and reliable videowall operation, DISPLAX recommends using hardware that meets the specifications below when integrating DISPLAX Tile systems. Recommended ...

• Connect Directly to the GPU

  Connecting DISPLAX TILE Directly to the GPU (DisplayPort or HDMI) As an alternative to Daisy Chain mode, each DISPLAX TILE unit can be connected directly to the computer’s graphics card (GPU) using either: DisplayPort (DP) HDMI The connection type ...

• Daisy-Chain Overview

  Daisy-Chain Setup Using Internal Videowall Processor DISPLAX TILE includes an internal videowall processor that allows multiple TILE units to be merged into a single display. In this configuration: TILE units are DisplayPort daisy-chained TILE units ...