Calibrating a Single Tile Unit

Calibrating a Single Tile Unit

If you're using a single DISPLAX Tile Pro unit, the calibration process is straightforward and mirrors the steps for calibrating a single DISPLAX Skin.

Steps to Calibrate:

  1. Open the CALIBRATION tab in the DISPLAX Connect software.
  2. Click the CALIBRATE button to initiate the process.

Calibration Targets:

  • Four calibration targets will appear sequentially on the screen.
  • Step 1: Touch target 1 and hold your finger on it until the green circle fully completes.
  • Step 2: Repeat this process for targets 2, 3, and 4 in order, following the on-screen instructions.

Tips for Accurate Calibration:

  • Ensure the screen is clean and free of dust or smudges to avoid interference.
  • Use consistent, firm pressure when touching the targets to improve accuracy.
  • Avoid leaning on or touching other areas of the screen during calibration.

    • Related Articles

    • Airflow Recommendations

      Airflow Recommendations for DISPLAX Tile Pro The DISPLAX Tile product is equipped with two internal fans designed to maintain proper operating temperature and ensure consistent performance. When these units are installed inside an enclosure, it is ...

    • Tile Pro RS232 Commands

      RS232 Communication Protocol I. Introduction This method uses a hexadecimal command set, provides a standard RS232 communication interface, and has a loop-out interface for cascading use. 1. Related Settings: Baud Rate: 9600 bps Parity Bit: None Data ...

    • RS232 and LAN

      RS232 The RS232 port on the DISPLAX TILE Pro provides a control interface that allows users to manage display settings remotely, such as powering on/off, adjusting brightness, or changing inputs. For setups with multiple TILE Pro displays, RS232 ...

    • DisplayPort - Daisy-chaining

      The DisplayPort (DP) daisy-chaining feature on the DISPLAX TILE Pro allows multiple displays to be connected in sequence. Here's a detailed explanation: DP1/DP2 Input Ports: These accept video signals up to 4K (3840 × 2160) at 60Hz resolution. (The ...

    • Video Wall Calibration

      DISPLAX Connect includes a new feature, Video Wall Calibration, designed to simplify the process of calibrating multiple TILE Pro units in a video wall or table setup simultaneously. DISPLAX Connect detects all TILE Pro devices connected to the PC ...