Connecting the Skin Fit Sensor to the Controller

Overview

A proper connection between the touch sensor's FPC cables (flex) and the touch controller (PCB) is essential to ensure optimal touch performance.

Each FPC cable has a specific connector port on the PCB. Ensure cables are fully seated and correctly aligned before locking the connector.

---

FPC Cable Connection 

Follow these steps to connect the flex cables securely:

1. Open the Connector Lock
   Raise the connector lock into a fully vertical position (90º), perpendicular to the touch controller board.
   

   Fig. 1 - Ribbon Cable and Connector
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   

2. Insert the FPC Cable
   While holding the controller steady, insert the FPC cable horizontally, making sure it's perpendicular to the open lock.
   

   Fig. 2 - Insert the Ribbon Cable
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   

3. Insert Fully
   Push the cable until it stops at the back of the FPC connector.
   

   Fig. 3 - Ribbon Cable Inserted
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   

4. Stiffener Lock Engagement
   Gently pull the cable slightly backward until the little tabs on the stiffener lock into position.
   

   Fig. 4 - Correct Position
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   

5. Close the Connector Lock
   Press down on the center of the connector lock to close it. Ensure the stiffener is perfectly aligned with the lock on both sides.
   

   Fig. 5 - Connector Locked
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   

❗ If the stiffener isn’t aligned or the cable isn’t centered, repeat the process. Misalignment can result in connection failure.

Fig. 6 - Bad Connection

Fig. 7 - Bad Aligment / Connection

• Related Articles

• General Integration Tips and Installation Best Practices

  DISPLAX Skin Fit DISPLAX Skin Fit is designed for thin, integrated touch solutions where space constraints and mechanical precision are critical. Correct integration is essential to ensure stable touch performance and long-term reliability. Glass and ...

• Connecting the Skin Ultra Sensor to the Controller

  Overview A proper connection between the touch sensor's FPC cables (flex) and the touch controller (PCB) is essential to ensure optimal touch performance. Each FPC cable has a specific connector port on the PCB. Ensure cables are fully seated and ...

• General Integration Tips and Installation Best Practices

  DISPLAX Skin Ultra Proper integration of DISPLAX Skin Ultra is critical to ensure reliable touch performance and long-term stability. Because Skin Ultra is designed for custom installations, careful attention must be given to mechanical mounting, ...

• Lamination Overview

  Lamination Overview for DISPLAX Skin Fit Lamination is the process of applying a DISPLAX Skin touch sensor onto a non-conductive surface such as glass. It ensures durability, accuracy, and stable touch performance. Key Steps Clean the glass – Use ...

• Lamination Overview

  Lamination Overview for DISPLAX Skin Ultra Lamination is the process of applying a DISPLAX Skin touch sensor onto a non-conductive surface such as glass. It ensures durability, accuracy, and stable touch performance. Key Steps Clean the glass – Use ...