Infinity Feature

Enable the Infinity Feature

The Infinity feature is designed to reduce cross-talk noise when placing multiple touch sensors side by side with a minimal gap. This ensures smooth and uninterrupted touch performance across touch sensors.

📍 Where to Enable It:
You can activate the Infinity feature in the ADVANCED tab of Displax Connect. Refer to the image below for guidance.

⚠️ Note:

The Infinity feature is only available on DISPLAX TILE and Skin ULTRA products.

• Related Articles

• Multiple Touch Controllers

  Overview Displax Connect supports multiple DISPLAX Touch Controllers connected to the same system. When more than one controller is detected, Displax Connect provides a dedicated interface to view, select, and manage each controller individually. ...

• Touch Optimization

  Touch Optimization in Displax Connect Touch Optimization is a setting that lets you adjust the balance between touch speed and touch smoothness to match your application needs. Factory Defaults For Skin Ultra and Skin Fit, the default is set midway ...

• Screens Selection

  Screens When multiple monitors are connected to your system, you can use DISPLAX Connect to choose which display will show the calibration screen. This ensures that the calibration targets appear on the correct monitor before you begin. How It Works ...

• Advanced Calibration – Multi Point

  Advanced Calibration – Multi Point The Multi-Point Calibration feature is used when more than four calibration points are required to improve touch accuracy across the entire sensor area. This is especially useful when: A single touch sensor covers a ...

• Infinity Feature

  The Infinity feature allows you to have multiple Touch Sensors side by side with the minimum gap possible. It will reduce the cross-talking noise between Touch Sensors to the point where it won't affect the touch performance. The following picture ...