Integration Tips and Installation Best Practices

Integration Tips and Installation Best Practices

DISPLAX Skin Mesh

DISPLAX Skin Mesh is delivered laminated on glass, eliminating lamination steps. However, proper mechanical and electrical integration remains essential for long-term performance and stability.

Unlike film-based sensors (Ultra / Fit), Skin Mesh does not have a separate tail.
The FPC (Flexible Printed Circuit) exits directly from the sensor and must be handled carefully.

Handling and Preparation

  • Handle the glass using clean gloves

  • Do not apply pressure to the active area

  • Never lift or carry the unit by the FPC

  • Store flat before installation

Before installation, inspect for:

  • Glass cracks or chips

  • FPC damage

  • Connector deformation

Mechanical Integration

Since the sensor is integrated into glass:

  • Ensure the display frame supports the glass evenly

  • Avoid point pressure or uneven mounting tension

  • Prevent frame torsion or structural bending

⚠️ Mechanical stress on the glass can impact touch accuracy.

FPC (Flexible Printed Circuit) Handling – Critical Area

The FPC exits directly from the sensor and is a sensitive electrical connection.

Best Practices

  • Do not sharply bend the FPC

  • Respect the minimum bending radius

  • Avoid routing near sharp metal edges

  • Do not trap or compress the FPC between mechanical parts

  • Provide strain relief near the controller connection

  • Ensure the FPC is not under tension once installed

⚠️ Damage to the FPC is permanent and may result in loss of channels or total failure.

Electrical and EMI Considerations

Skin Mesh includes XTR-Shield™ Plus for enhanced noise resistance. However:

  • Proper grounding of metallic structures is still required

  • Keep controller and cables away from:

    • Power supplies

    • LED drivers

    • High-current lines

  • Use shielded USB cables

Good grounding improves long-term stability.

Controller Placement

  • Install in a ventilated location

  • Keep away from heat sources

  • Avoid placing directly against high-EMI components

  • Ensure easy access for maintenance

Before Powering On

  • Confirm FPC routing is stress-free

  • Verify connectors are fully seated

  • Check grounding continuity

  • Ensure no metallic parts contact exposed traces

Final Recommendations

  • Perform full-surface touch testing

  • Close DISPLAX Connect after configuration

  • Re-test after final enclosure assembly

    • Related Articles

    • Assembly Process

      Overlay Integration DISPLAX Skin Mesh overlays are designed for quick and clean integration. The overlay is secured directly to the LCD using the included brackets and M3 screws, with minimal setup time. Depending on the display size, the number of ...

    • Controllers and Config

      Controllers and Configuration (Config ID) Depending on the sensor size, DISPLAX Skin Mesh requires a specific Touch Controller. Using the correct controller and configuration is essential for proper operation. Available Controllers DISPLAX provides ...

    • Mesh Calibration

      Calibration The DISPLAX Skin Mesh is designed to provide a Plug & Play experience using HID (Human Interface Device) technology. This means no drivers are required. However, in rare cases where there is a visible offset in touch accuracy, manual ...

    • Assembly Video Tutorial

      Mesh Overlay – Assembly Video Tutorial This video tutorial provides a step-by-step guide to assembling and installing the DISPLAX Skin Mesh Overlay Kit onto an LCD display. In this demonstration, you will learn: How to prepare the workspace for ...

    • Fine-Tuning

      Fine-Tuning and Auto-Tune (Tune Feature) Unlike other DISPLAX Skin products, Skin Mesh does not require manual fine-tuning. Skin Mesh includes an Auto-Tune algorithm that continuously adjusts the controller parameters automatically. This system ...