DISPLAX TILE supports control and configuration via RS232 communication.
RS232 can be used for:
Power ON / OFF commands
Input source selection
Brightness and OSD control
Videowall configuration commands
Integration with third-party control systems (Crestron, AMX, etc.)
For the complete list of RS232 commands, syntax, and communication parameters, please refer to the official command reference sheet:
👉 RS232 Command Reference Sheet
This document includes:
Command structure
Hexadecimal format
Parameter descriptions
Response format
Communication settings
Before sending commands, ensure your system matches the correct serial settings:
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Always verify the correct COM port when connecting via the included RJ45-to-RS232 adapter.
TILE units must be powered ON for RS232 communication.
For videowall configurations, units must also be RS232 daisy-chained.
When using Screenc Control software, RS232 connection is required for screen mapping and merging.
Only use certified serial adapters for reliable communication.
When integrating with third-party automation systems:
Test commands individually before deployment
Confirm command acknowledgement responses
Label each TILE ID correctly in videowall setups
If you experience communication issues, verify:
COM port assignment
Serial adapter drivers
Correct baud rate configuration