Touch Button Operations
Stand-by, ON, and OFF
The Touch Injection status defines whether the Touch Controller is actively processing touch signals. Understanding how the ON, STAND-BY, and OFF modes work ensures correct setup and avoids touch input issues.
Initial Setup
When configuring the Touch Controller for the first time, make sure the Touch Injection status is set to ON before closing DISPLAX Connect.
🟠 By default, the controller ships with Touch Injection set to OFF.
If the controller is left OFF, touch signals will not be processed.
Behavior When Reopening DISPLAX Connect
If Touch Injection was set to ON before closing DISPLAX Connect, it will switch to STAND-BY the next time the software is opened.
This is normal:
-
When DISPLAX Connect is open, touch is temporarily disabled (STAND-BY mode).
-
When you close the application, touch is automatically re-enabled (ON mode).
💡 STAND-BY only applies when DISPLAX Connect is running.
It allows you to adjust settings safely without triggering unwanted touch input.
Disabling the Stand-by Feature
If you prefer that the touch status does not change automatically when opening or closing DISPLAX Connect:
-
Toggle the Stand-by switch to OFF.
-
The controller will then remain in its current state (ON or OFF) at all times.
⚠️ Important Notes
-
Keep DISPLAX Connect closed after completing configuration. Leaving it running may reduce touch responsiveness.
-
All settings are saved directly to the Touch Controller, so they remain even if you change or replace the computer.
Related Articles
Upgrade Touch Controller Firmware
Firmware Upgrade When a new firmware version becomes available for your DISPLAX Touch Controller, you’ll see an Update button next to the current firmware version inside DISPLAX Connect. Updating the firmware ensures your controller is running with ...Touch Controller Information
Touch Controller Information At the top-left corner of the DISPLAX Connect interface, you’ll find essential information about the connected Touch Controller. This section helps identify, manage, and track each controller in your setup. Information ...What is DISPLAX Cast?
What is DISPLAX Cast? DISPLAX Cast is a remote configuration feature available in DISPLAX Connect 3.0 and newer. It allows you to configure any compatible DISPLAX touch controller remotely, without needing to be physically connected to the device. ...How to activate DISPLAX Cast?
How to Activate DISPLAX Cast The DISPLAX Cast feature allows you to remotely configure DISPLAX touch controllers connected to another computer. Before using it, you must enable network discovery on the host machine where the controller is physically ...Advanced Calibration – Drag mode
Drag Mode Calibration Overview Drag Mode Calibration is used when you need to define a custom active area on a DISPLAX Skin touch sensor — for example, when the sensor shape or usable touch area is smaller than the full sensor size. This mode lets ...