Touch injection warning on close

When closing Displax Connect with the Touch button set to OFF, you will see a prompt confirming whether you wish to enable the Touch injection in the operating system, or leave it off:

• Related Articles

• Touch Representation

  Enable or disable touch representation:

• Touch Optimization

  Optimization is a parameter that allows choosing the balance between speed and smoothness of Touch. Factory settings are halfway between Touch speed and Touch smoothness for Skin Ultra and Skin Fit; for Skin Dualtouch the factory settings slightly ...

• Touch Controller Information

  In the upper-left corner of DISPLAX Connect, you can find useful information, such as: Product Name Touch Controller Firmware Version Touch Controller Serial Number Label, which can be changed to a user-friendly word

• Enable / Disable areas of the touch sensor

  You may need to disable specific Rows and/or Columns. For that, you can click on the Sensor Tools button and use the numbers around the edge of the Sensor Tools view to disable a specific row/column. In the following example we disable rows 0, 1, and ...

• Stand-by, ON and OFF

  Stand-by, ON, and OFF Touch Injection Modes in Displax Connect When setting up your touch controller for the first time, it’s essential to set the Touch Injection status to ON before closing Displax Connect. The factory default is OFF, and leaving it ...