What is considered good touch performance?
Having continuous touch without losing detection when dragging one finger, held 90ยบ relative to the display, with minimal finger pressure. Test across the entire active area of the sensor, center and borders.
Repeat the previous step, using 2 or more fingers, without losing touch detection.
Drag with one hand, touching with 4 fingers, from one side to the opposite side of the active area of the sensor (left-hand dragging from left to right; right-hand from right to left), without losing touch detection.
Note: This is a reference example for a display of 42 inches. For larger sizes, a proper distance between two or more fingers is needed to obtain good touch detection. Displays with bigger dimensions require more distance between fingers. The values of the distances are specified on the technical specifications provided along with each touch sensor.
Related Articles
Touch Accuracy Offset
After obtaining an optimal touch performance and calibrating a touch sensor, if you find there is an offset to the accuracy of where the physical touch is in relation to where it shows on the display, please check 2 things: 1. Scaling applied in the ...
How to activate the touch in the operating system
In order to get touch interaction in the operating system itself, you must ensure that the Touch Injection button is set to the ON position.
Touch Controller not detected in DISPLAX Connect
No Touch Controller Detected There are many reasons a Touch Controller may not be detected by a computer. Ensure you double-check: All the motherboard drivers are properly installed (Windows) If the USB drivers of the computer are not installed, or ...
Rotate or Swap Touch Calibration - Linux
If you are using a Linux operating system, or any OS that doesn’t support DISPLAX Connect, you may need to rotate or swap the X and Y coordinates (for example: Raspbian, Ubuntu Mate or Raspberry PI 3). To do this just follow the steps below. ...
MacOS Monterey Workaround to Enable Touch
With the release of macOS Monterey, touch no longer works by default with DISPLAX touch controllers. DISPLAX developed the following workaround. Software Needed DISPLAX Connect - used to configure the touch controller and to communicate via TUIO ...