Lamination
Post-Drying Cleaning Process
Lamination Cleaning process after drying Clean both sides using a soft, lint-free cloth dampened with water. Visually inspect the touch sensor to check there are no fingerprints, dirt, or other contaminants. For future cleaning and maintenance, ...
Drying Period
Lamination Drying Period Leave the laminated touch sensor and glass to dry for 24 hours in a suitable, clean area, placing it flat, touch sensor side facing up. Do not touch the touch sensor while it is drying. Ideally, the drying area should have ...
Remove Remaining Water
Lamination Removing the remaining water After the lamination process, gently remove the remaining liquid using a clean, cotton, lint-free cloth (Fig.28) Fig. 28
Laminating with MIX and Squeegee
Lamination Lamination with the MIX Solution and Squeegee Use "squeegee 2" exclusively to laminate the touch sensor onto the glass, and start removing the Mix Solution. The Mix removal should follow the sequence and directions of the arrows as ...
Placing the Touch Sensor on the Glass
Lamination Laying the Touch Sensor over the Glass To remove the touch sensor from the wall, wet your fingers to prevent fingerprint marks on the film glue (Fig.16) Fig.16 To avoid folding or creasing the touch sensor, two people are required to ...
Protective Layer
Lamination Peeling-off the Touch Sensor Protective Layer Prepare the wall to laminate the touch sensor. Spray the wall with water to allow the touch sensor to adhere to the wall (Fig.5). Fig.5 Pick up the touch sensor and apply it against the ...
Glass Cleaning
Lamination Glass Cleaning The glass must be free of debris and other contaminants. Duly clean the glass using the MIX and a squeegee - “squeegee 1” (Fig.2 and 3). If the glass contains oils, grease, or hard-to-remove dirt, you can clean the glass ...
Solution and Care
Lamination Solution Mixture and Care To laminate the touch sensor onto glass, you need to prepare a liquid solution (MIX). The MIX is comprised of distilled or bottled water with 10% of Johnson's baby shampoo, i.e. for a spray bottle of 1000 ml, use ...
Resources
Lamination Tools and Materials Here we demonstrate how to laminate a Displax touch sensor foil on glass. Please be sure to test all touch sensor foils before lamination, as described in the previous chapter. Two people are required to perform the ...
Overview
Lamination Overview The Touch Sensor must be laminated onto a non-conductive substrate, such as glass, acrylic, corian, wood, mirror, or other non-conductive material. The touch sensors are available in 2 versions, permanent and removable: The ...