Start a conversation

Displax Connect Command Line

Tweak your touch sensor with the extensive shell command list we have available

  • How to access the Displax Connect Command Line?

    This tool can be found on the same folder where the Displax Connect is installed (Windows and macOS). If you type skin -h you will see all the possible parameters you can use with the command skin, th...

  • How to activate TUIO?

    All Displax products offer the end users the possibility to activate the TUIO protocol, allowing them to get over the network values: X coordinate; Y coordinate; Pressure Sensing (only for Displax Ski...

  • How to enable/disable the touch injection in the Operating System?

    With the Displax Connect Command Line you are able to control if the touch is being injected on the Operating System or not. In order to achieve this in any of the supported operating system follow th...

  • How to control the touch mode?

    By default the Displax Touch Controllers are automatically defined with the correct touch mode for each operating system. There are three possible modes to be defined: Mouse emulation (0) Single Touch...

  • How to set/get the Threshold?

    Displax Connect Command Line gives you the possibility to set/get the threshold over the command line. In  order to achieve this in any of the supported operating system follow these steps: Be sure th...

  • How to factory reset the Touch Controller?

    Displax Connect Command Line gives you the possibility to factory reset all values. In  order to achieve this in any of the supported operating system follow these steps: Be sure that you are on the l...

  • How to load/save the settings of a Touch Controller?

    Displax Connect Command Line allows you to load or save all the settings and calibration values from one Touch Controller to another with the same model and firmware version. In  order to achieve this...

  • How to create a new frame of reference?

    The frame reference feature consists in making the actual frame data the one that is going to be used for reference when the system tries to determine if we are get a touch or not. In  order to achiev...

  • How to restart the touch controller?

    In  order to achieve this in any of the supported operating system follow these steps:     Be sure that you are on the location of the Displax Connect installation To archive this run the following co...

  • How to set/get the Gain?

    Displax Connect Command Line gives you the possibility to set/get the Gain over the command line. In  order to achieve this in any of the supported operating system follow this steps: Be sure that you...