DISPLAX Service Overview
DISPLAX Service is a background process (agent/daemon) installed alongside DISPLAX Connect that enables low-level communication with your DISPLAX Touch Controllers. It acts as a command-line interface, allowing advanced control, scripting, automation, and integration with tools (such as the DISPLAX SDK).
DISPLAX Connect uses DISPLAX Service to perform actions, communicate settings to hardware, and support features like remote configuration. Because it runs at a system level, the service must be installed and running to work with DISPLAX Connect via command-line interfaces.
Why DISPLAX Service Matters
DISPLAX Service enables:
-
Command-line control of touch settings and diagnostics
-
Integration support for automation and development tools
-
Remote configuration features (DISPLAX Cast)
-
Direct communication with DISPLAX hardware independently of the UI
It is a key component of advanced workflows beyond basic sensor calibration and configuration.
Tips & Best Practices
-
Ensure that DISPLAX Service is installed and running before using advanced features.
-
On Windows, confirm that the service directory exists and that firewall or antivirus software is not blocking access.
-
If you require remote discovery over a network, make sure network discovery is enabled and that DISPLAX Service is allowed through firewalls.
Related Articles
Windows
Default Installation Location — Windows When DISPLAX Connect 4.0.0 is installed on a Windows computer, the DISPLAX Service component is placed in the following default directory: C:\Program Files\DISPLAX\Service\bin This location is useful when ...
Allow Network Connections
DISPLAX Service – Allow Network Connections Overview DISPLAX Service can be configured to accept or block connections from other devices on the network. This setting controls whether remote hosts are allowed to connect to DISPLAX Service for ...
Touch operation mode
Overview By default, DISPLAX Touch Controllers automatically select the correct touch operation mode for the operating system in use. In most cases, no manual configuration is required. However, if your application or environment requires a specific ...
Connect to a host
DISPLAX Service – Connect to a Host Overview To view or modify settings on a touch device using DISPLAX Service, you must first connect to the host computer where the device is attached. This applies to both local devices (connected to the same ...
Ubuntu
Default Installation Location — Ubuntu After installing DISPLAX Connect on Ubuntu, the DISPLAX Service files are located in the following directory: /opt/displax/ You can access DISPLAX Service directly from the terminal as shown below: