How to activate the touch in the operating system

In order to get touch interaction in the operating system itself, you must ensure that the Touch Injection button is set to the ON position.

• Related Articles

• Touch Controller not detected in DISPLAX Connect

  No Touch Controller Detected There are many reasons a Touch Controller may not be detected by a computer. Ensure you double-check: All the motherboard drivers are properly installed (Windows) If the USB drivers of the computer are not installed, or ...

• MacOS Monterey Workaround to Enable Touch

  With the release of macOS Monterey, touch no longer works by default with DISPLAX touch controllers. DISPLAX developed the following workaround. Software Needed DISPLAX Connect - used to configure the touch controller and to communicate via TUIO ...

• Rotate or Swap Touch Calibration - Linux

  If you are using a Linux operating system, or any OS that doesn’t support DISPLAX Connect, you may need to rotate or swap the X and Y coordinates (for example: Raspbian, Ubuntu Mate or Raspberry PI 3). To do this just follow the steps below. ...

• What is considered good touch performance?

  Having continuous touch without losing detection when dragging one finger, held 90º relative to the display, with minimal finger pressure. Test across the entire active area of the sensor, center and borders. Repeat the previous step, using 2 or more ...

• Touch Accuracy Offset

  After obtaining an optimal touch performance and calibrating a touch sensor, if you find there is an offset to the accuracy of where the physical touch is in relation to where it shows on the display, please check 2 things: 1. Scaling applied in the ...