Advanced Settings
Maximum number of touches
Limits the number of touches reported by the Touch Controller to a specified number (Skin Ultra: up to 100 touches; Skin Fit: up to 40 touches; Skin Dualtouch: up to 2 touches). This feature is available depending on the version of the Touch ...
Load & Save Settings
When you have multiple units with an identical setup, it is useful to save the Touch Controller settings for uploading to other units. It can also be useful to save the touch controller settings, in case someone changes the configuration parameters, ...
Load Firmware
Load Firmware from a File This feature is available when there is no Internet access on site. If you have Internet access you won’t need to use this feature, because DISPLAX Connect will automatically check your firmware version and let you know if ...
Infinity Feature
The Infinity feature allows you to have multiple Touch Sensors side by side with the minimum gap possible. It will reduce the cross-talking noise between Touch Sensors to the point where it won't affect the touch performance. The following picture ...
Factory Reset
Sets the Touch Controller to its default settings. A warning message will be displayed: ‘YOU ARE ABOUT TO SET THE FACTORY DEFAULT SETTINGS’. Click ‘! RESET !’ to proceed.
Touch Optimization
Optimization is a parameter that allows choosing the balance between speed and smoothness of Touch. Factory settings are halfway between Touch speed and Touch smoothness for Skin Ultra and Skin Fit; for Skin Dualtouch the factory settings slightly ...