Post-Drying Cleaning Process

Post-Drying Cleaning Process

Cleaning Process

Once the 24-hour drying period is complete, the laminated touch sensor is ready for a final cleaning step to ensure optimal transparency and touch performance.

Cleaning Instructions

  1. Use a soft, lint-free cloth (e.g., microfiber).

  2. Slightly dampen the cloth with clean water — avoid oversaturating.

  3. Wipe both sides of the glass (top and bottom).

  4. Visually inspect the sensor for:

    • Fingerprints

    • Dust or dirt

    • Smudges or contaminants

Tips & Precautions

  • Avoid using alcohol, solvents, or abrasive cleaners.

  • Do not apply excessive pressure.

  • If any particles persist, gently repeat the cleaning process with a new dampened cloth.


For ongoing maintenance and regular cleaning, please refer to the guide: Cleaning Methods for DISPLAX Touchscreens

    • Related Articles

    • Drying Period

      Lamination > Drying Period After lamination, it's crucial to allow the laminated touch sensor and glass to dry undisturbed for 24 hours in a clean, controlled environment. Drying Procedure Place the laminated assembly flat, with the touch sensor side ...

    • Glass Cleaning

      How to clean the glass before laminating the Displax touch sensor? Before laminating your touch sensor, the glass surface must be thoroughly cleaned. Any dust, oil, or debris may impact touch performance or cause bubbles. Cleaning Method Step 1 – ...

    • Assembly Process

      Overlay Integration DISPLAX Skin Mesh overlays are designed for quick and clean integration. The overlay is secured directly to the LCD using the included brackets and M3 screws, with minimal setup time. Depending on the display size, the number of ...

    • Lamination

      Skin Zeeto Lamination Process The correct lamination to glass of the Skin Zeeto sensors ensures durability, accuracy, and long-term performance. This article explains the recommended step-by-step lamination process. A full video tutorial can also be ...

    • Remove Remaining Water

      How to remove remaining water after lamination After completing the three squeegee passes during lamination, you must gently remove any remaining MIX solution or surface moisture from the glass and sensor surface. Step-by-Step Instructions Use a ...