Lamination
Post-Drying Cleaning Process
Cleaning Process Once the 24-hour drying period is complete, the laminated touch sensor is ready for a final cleaning step to ensure optimal transparency and touch performance. Cleaning Instructions Use a soft, lint-free cloth (e.g., microfiber). ...
Drying Period
Lamination > Drying Period After lamination, it's crucial to allow the laminated touch sensor and glass to dry undisturbed for 24 hours in a clean, controlled environment. Drying Procedure Place the laminated assembly flat, with the touch sensor side ...
Remove Remaining Water
How to remove remaining water after lamination After completing the three squeegee passes during lamination, you must gently remove any remaining MIX solution or surface moisture from the glass and sensor surface. Step-by-Step Instructions Use a ...
Laminating with MIX and Squeegee
Lamination Method Use this method to properly adhere the Displax touch sensor to the glass using the MIX solution and “squeegee 2.” Preparation Use “squeegee 2” only for lamination (do not reuse from cleaning) Confirm the touch sensor is already ...
Placing the Touch Sensor on the Glass
How to place the Displax touch sensor on the glass After removing the protective liner, you must gently transfer the touch sensor from the wall to the glass substrate. This step requires care to avoid wrinkles, folds, or grid misalignment. Step 1 – ...
Protective Layer
How to peel off the protective layer from the touch sensor? Before beginning lamination, the protective layer on the adhesive side of the Displax touch sensor must be carefully removed. This layer prevents contamination and damage during handling and ...
Glass Cleaning
How to clean the glass before laminating the Displax touch sensor? Before laminating your touch sensor, the glass surface must be thoroughly cleaned. Any dust, oil, or debris may impact touch performance or cause bubbles. Cleaning Method Step 1 – ...
Solution and Care
How do I prepare the solution to laminate a Displax touch sensor? To properly laminate a Displax touch sensor onto a glass substrate, you must prepare a MIX solution that allows for repositioning and air-bubble-free installation. MIX Solution – Water ...
Resources
What tools and materials do I need to laminate a Displax touch sensor? This guide lists all the essential tools and resources needed to laminate a Displax touch sensor onto a glass substrate. ⚠️ Important: Always test the sensor before lamination. ...
Overview
What are the lamination options for Skin Ultra & Skin Fit touch sensors? Before installing a Displax touch sensor, it must be laminated onto a non-conductive substrate such as: Glass Acrylic Wood Mirror Corian or other non-metallic materials Using ...